Overhead Stirrer Multi Mixer MM-1000
Edition 2.04
– December of 2021
Operating Manual
Page 5
MP-1
MP-2
MP-3
MA-1
MC-1
Double clamp
Support stand SRB
4.3.
Assembly of the optional SRB stand.
-
Unpack the stand. Place the platform on a flat, stable horizontal surface.
-
Using the spanner provided, remove the 10 mm nut from one of the two stand parts.
-
Screw either part of the stand into the hole in the platform until it stops. Use a spanner to fix
the nut to the stand thread protruding under the platform.
-
Screw the second part of the stand onto the top of the first part.
-
Place the rubber mat on the platform.
4.4.
Setup of the appliance
.
-
Screw the nut (fig. 1/2) onto the threaded rod on the vertical rod (fig. 1/1).
-
Screw the threaded rod (fig. 1/1) into the hole (fig. 1/4) on the rear panel of the appliance. Se-
cure it with the nut by turning it clockwise.
-
Fasten the appliance to a stand with the double clamp.
-
Fix the stirring rod (fig. 1/6) in the clamp (fig. 1/5) without applying excessive transverse axial
force.
-
Connect the external power supply to the connector on the back of the appliance.
-
Remove the protective film from the display.