Batteryless Start Booster Chargers
:
This series is called CAP. It comes in various sizes and is designed for our line of Batteryless
Jump Starters. When the unit is fully charged, please remove the charger and do not keep it in
charge.
Other methods to recharge your Batteryless Start Booster
:
You can recharge your Batteryless Start Booster by connecting its clamps to a good well charged
12V battery. Depending on the size of the battery, it can take up to a few minutes to recharge your
Booster.
Another way to recharge a Batteryless Start Booster would be to leave it connected for 10-15
seconds
maximum
to the engine/alternator of the vehicle after it has started. The alternator will
recharge it immediately. (Please make sure to remove the clamps after 15 seconds max.)
Make sure to only use the supplied charger. Using a non-authorized charger will void the warranty
and can be dangerous. Batteries or Capacitors that are overcharged will inflate and start pro-
ducing gases, which may cause an explosion or a fire. That is why we only recommend using the
supplied charger in a well ventilated area.
4. OPERATING INSTRUCTIONS
Always wear safety equipment before trying to jump start your vehicle. Make sure the area is well
ventilated and that the terminals are clean.
Also make sure that your unit is fully charged before attempting to jump start.
If you have a 12/24V unit, make sure that the voltage selector switch is on “OFF” or that the red
voltage connector plug is unplugged. If you have a 12V (or 24V) unit with ON\OFF switch, make
sure it is turned OFF. Please also make sure that the cables are not in the path of moving parts of
the vehicle’s engine.
The battery terminal not connected to the frame should be connected first. The other terminal
should be connected to the frame, far from the battery and the fuel line. After the start, remove
the frame connexion first, then the connexion from the battery in the same order.
Please turn OFF the air conditioning, the radio and the lights before the jump start.
A.
BATTERY START BOOSTER
1. Connect the positive (red) clamp to the positive terminal.
2. Connect the negative (black) clamp to the frame of the vehicle (ground).
3. If you have a 12/24V unit, choose the voltage with the voltage selector switch or
with the voltage connector plug 12V or 24V. If you have a 12V or 24V unit with
ON/OFF switch, turn it ON.
4. Then start your engine and stay clear of the battery and the Start Booster
while jump-starting. Make sure that it cannot fall inside the engine compartment.
5. Once started, first disconnect the black (negative) clamp, then place the
voltage selector switch on OFF; or unplug the voltage connecter plug from the
12/24V unit.
6. Then disconnect the red (positive) clamp.
7. Store both clamps immediately in their respective placing.
8. Recharge the Jump Starter with the supplied automatic charger.
Important: Should the vehicle refuse to start within 10 seconds, have the Start Booster cool
down for 3 minutes before the next attempt. If it still doesn’t start, have your car battery or
06
Summary of Contents for START BOOSTER 12/24V
Page 51: ...NOTES 51...
Page 52: ...L06201801...
