BEFORE OPERATING YOUR CRAFT
38
CHECKING THE BOAT AND EQUIPMENT
Using a pressure gauge, check inflation pressure in each section of the tube (gauge not supplied).
Check the tightness of the outboard motor clamps or bolts.
Remove the cockpit drain plug and check it is working correctly.
Check the cockpit drain plug gasket, replace if necessary.
Check that the fuel tank is correctly installed and secured.
Top off fuel and lubricating oil levels to required levels. Note: do not overfill fuel tank.
Check that sufficient fuel is available for your trip.
Be sure the outboard motor is not in gear before attempting to start.
Start the engine and check that the emergency kill switch functions correctly.
Check the load is evenly distributed.
Be sure that all navigation lights are in working order.
Check that all required safety equipment is on board (horn, first aid kit, waterproof light, cell
phone in watertight case, fresh water reserve etc.). See also
“SAFETY EQUIPMENT” in the section “SAFETY”.
Check that each passenger has his personal flotation device.
Check that the boat is equipped with an additional flotation device for emergency use.
Check that the boat is equipped with two oars/paddles. Check the condition of the oars and
rowlocks.
Be sure that you do not exceed the recommended maximum load indicated on the Builder’s plate.
Summary of Contents for Golden Line G850
