LIGHTING INSTRUCTIONS
WARNING: IMPORTANT!
BEFORE LIGHTING…
Inspect the gas supply hose prior to turning the gas
“ON”. If there is evidence of cuts, wear, or abrasion, it
must be replaced prior to use. Do not use the grill if the
odor of gas is present. Only the pressure regulator and
hose assembly supplied with the unit should be used.
Never substitute regulators for those supplied with the
grill. If a replacement is necessary, contact the factory
for proper replacement.
Screw the regulator (type QCC1) onto the tank. Leak
check the hose and regulator connections with a soap and
water solution before operating the grill (see assembly
instruction page 9).
TO LIGHT THE GRILL BURNER:
Make sure all knobs are “OFF” then turn on the gas
supply from the LP tank. Always keep your face and
body as far from the grill as possible when lighting.
Your Kirkland Signature has an exclusive patented built-
in ignition. The igniter is built in to the valve. To ignite
each burner simply push and turn the control knobs to
the HI setting, you will hear the valve click as it sends a
spark to the pilot flame. If the burner does not light wait
5 minutes for any excess gas to dissipate and then retry.
Flame Characteristics
Check for proper burner flame characteristics. Each
burner is adjusted prior to shipment; however, variations
in the local gas supply may take minor adjustments
necessary.
Burner flames should be blue and stable with no yellow
tips, excessive noise, or lifting. If any of these conditions
exist call our customer service line. If the flame is
yellow, it indicates insufficient air. If the flame is noisy
and tends to lift away from the burner, it indicates too
much air.
TO MATCH LIGHT THE GRILL:
If the burner will not light after several attempts then the
burner can be match lit.
If you’ve just attempted to light the burner with the
igniter, allow 5 minutes for any accumulated gas to
dissipate. Keep your face and hands as far away from the
grill as possible. Insert a lit extended match or lighter
through the cooking grids to the burner. Press the control
knob and rotate left to the HI setting, continue to press
the knob until the burner ignites. Burner should light
immediately. If the burner does not light in 4 seconds
turn the knob off, wait 5 minutes and try again.
TO LIGHT THE ROTISSERIE BURNER:
Open the lid, push the knob for about 5 seconds without
rotating. This will allow time for the gas to flow into the
rear burner. Continue pushing for 5 seconds then turn the
knob to the HI position, then press the igniter button to
light the rotisserie burner. If the burner does not light,
turn the control knob to “OFF”. If the igniter does not
function, follow the instruction above for match lighting.
Keep a spray bottle of soapy water near the gas supply
valve and check the connections before each use.
Do not attempt to light the grill if odor of gas is present.
Call for service 1-800-913-8999.
12
