765041982
Rev. 000
21
Thawing program
In connection with thawing, a defrosting heating element is used,
which is governed by the temperature that the room sensor measures.
The thawing program is only able to start when the desired
temperature value is set to b2
C and +8
C.
The program is started by pressing the button
.
starts the function.
When the desired value is attained, an
acoustic signal will be emitted.
After the signal, defrosting is
commenced (if such is required based
upon the evaporator sensor's
temperature). Afterwards, the storage
program is switched to.
Manual defrosting of the evaporator
Manual defrosting is only possible as initial defrosting:
Start
a
program:
Press
on
(wait
for
10
seconds).
Press
on
in
order
to
end/interrupt
the
program
again.
This
then
causes
defrosting
to
be
commenced
Do not use pointed or sharp objects to make defrosting go faster!
Automatic defrosting of the evaporator
The unit performs automatic defrosting 1 to 8 times daily, when the "PCL",
"HCL" and "SCL" programs have finished.
Defrosting cannot be concluded
manually! In connection with this, the internal temperature inside the unit is
shown before the defrosting process commences.
Summary of Contents for BAKER SF 550
