8
EN
5.1 CONNECTING THE CABLE
Loosen the screws fi xing the left side of the oven
and extract it.
The oven must be connected to the electricity with
a rubber cable such as H07RN-F.
WARNING: the yellow/green voltage wires in the
earth cable must be 3 cm longer than the others.
The appliance has terminal strips such as those in
the diagram. To connect to the electricity, see the
label in the manual and stuck to the bottom of the
back of the device beside the information plate.
The appliance has terminal strips such as those in
the diagram. To connect to the electricity, see the
label in the manual and stuck to the bottom of the
back of the device beside the information plate.
Proceed as follows to connect the power supply
wire to the terminal board:
• (A1) Loosen the tops of the cable gland and open
the bottom part of the back of the appliance by
loosening the screws.
• (A2) Feed the new cable through the cable gland.
Connect the cable voltage to the terminal strips
following the connection diagram on the label
on the back of the appliance. Only connect what
is indicated inserting the copper bridge and the
electricity cable together under the screws, in
the tightening direction, so the cable and the
bridge are tightly fi xed by tightening the screw.
The type of cable to be used (HO7RN-F) is indi-
cated on the label for each connection and the
voltage sections in mm².
• (A4) Close the bottom part of the back of the ap-
pliance by tightening the screws and fi t the cable
by tightening the cable gland top.
A1
A3
A2
A4
Summary of Contents for 223727
Page 32: ...32 PL A1 A3 A2 A4 A1 A3 A2 A4 ...
Page 51: ...51 PL ...
