The equipment type is shown on the first line and the software check in progress is shown
in the second line.
If after the initial installation check all is correct, the LCD indicator will display the fill level
(in %).
The figure 7 shows the LCD-display in the operation mode. The display shows the filling
level and the operating modes as abbreviations: "FV" and "P". These abbreviations corre-
spond as follows:
FV+
: filter valve opened
FV-
: filter valve closed
P+
: (pump on) house waterworks in operation
P-
: (pump off) no water currently being withdrawn
6.
Set up of the system control
After putting into operation, the system control must be adjusted and programmed accord-
ing to the conditions and requirements of the individual users system. The required set-
tings are easily programmed. There are four buttons for this purpose. All necessary pro-
gramming data entries follow a menu displayed by the LCD. Begin the programming of the
settings by pressing the button marked “
MENU
”. With the buttons “ ” or “ ” the menu
may be scrolled backwards and forwards. With the respective menu point shown the
values may be altered. For this the button “
OK
” must be used. The “?” displayed in the
LCD will now change to a “>”graphic character. With the “ ” or “ ” the desired value may
now be entered according to individual requirements. When the desired value has been
entered this must be confirmed by pressing the “
OK
” button. The value is only then taken
14
Picture 7: Display in the operation mode
Tank: FV- P-
50%
Status of rain water
filter flashing valve
Fill level in %
Visual check of the fill level
Status house waterworks
(pump + on / - off)
Summary of Contents for 351021
Page 27: ...Space for your notes 27 ...