F
R E E D O M
2 8 5
8–10
G
RILL
O
PERATION
Operation with Shorepower Available
1. Connect shore power. Green LED for shorepower available should be illuminated.
(Reference shore connection procedure)
2. Turn on the breaker under the gunnel.
3. On the remote inverter panel, press the switch up to the “shorepower” position. The “shore-
power/charger” LED will illuminate. The unit is now in “pass through” mode and the
inverter battery is automatically being charged by the inverter/charger.
Operation from Inverter Battery Power
1. Turn on battery switch located on the starboard side of the aft rigging compartment.
2. On the remote inverter panel, press the switch down to the “on” position. The “inverter”
LED will illuminate. The unit is now in “inverter” mode and power is being delivered to the
grill by the inverter battery.
3. There is an inverter battery status monitor located on the AC main electrical distribution
panel. To operate press and hold the test button located on the monitor. A green LED will
appear representing 100%, 50% or depleted. If the unit is in shorepower/pass through mode
when the test button is pressed, a red LED will appear indicating “charging”.
4. See Grill Owner’s Manual in owner’s packet for more detailed informational using this
accessory.
Inverter Battery Care
1. The inverter battery is an 8D gel cell. There is no inspection related maintenance required
for a gel battery; however, it is important that it be recharged frequently to optimize battery
life. A battery that is maintained by charging after each use will achieve a longer life than
one that is kept in a discharged state. Never store the battery for an extended period
completely discharged.
2. After several years of use it will be necessary to replace your inverter battery. It is recom-
mended to use the same type and size battery as originally installed to ensure proper system
performance.
H
EAD
O
PERATING
I
NSTRUCTIONS
Marine Head (with Hand Pump) Operation
1. Open the marine head inlet seacock by pulling up on the remote arm. This seacock is in the
forward bilge and is labeled “Head Inlet”. It can be accessed through the access plate in the
rigging lid between the consoles.
2. Position the wet/dry bowl selector in the wet bowl setting. Fill the toilet with water by
pumping the handle several times.
3.
Flush
the toilet by pumping the handle several more times in the wet bowl position.
4. Move the bowl selector to the dry bowl position and pump the handle until almost all of the
water is removed. Leave the toilet in the dry bowl position when not in use.
Summary of Contents for Freedom 285
