![background image](http://html1.mh-extra.com/html/graco/xm-pfp-273231/xm-pfp-273231_repair-and-parts-manual_2251613017.webp)
Repair
3A8047B
17
6. Remove front display panel (504d) and
gasket (504g).
7. Discard old display assembly.
8. Place new front display panel (504d) and
gasket (504g) on front panel of control box (16).
NOTE:
To ease installation use clear tape to hold front
display panel in place.
9. Carefully connect display cables and key switch
cable to new circuit board.
10. Install new rear display panel (504c) and secure
with four screws (504f). Ensure key switch cable
protrudes from opening in top of display module.
11. Install access cover and screws.
12. Reconnect CAN cable to display module.
13. Reconnect power.
15. Replace shroud.
16. Configure system settings as they were set on old
display. See XM PFP Operation manual for
instructions.
Replace Front Panel
See
, page 16, for instructions.
Upgrade Software
1. Download all USB logs. The new software will erase
the USB logs. See operation manual for
instructions to Download Data from USB.
2. Turn off power to the system.
3.
Remove Shroud and Front Panel of Control Box
see page 14.
4. Remove four screws (504f) then remove access
cover (504e).
5. Insert and press token (506) firmly into slot.
NOTE:
There is no preferred orientation of token.
6. Turn power on.
7. The red indicator light (L) will flash until new
software is loaded on the display module.
8. All system modules will be automatically updated.
See Graco Control Architecture Module
Programming manual for details.
9. Remove token.
10. Reinstall shrouds and front panel.
r_
xm
1a
00
_3
12
35
9_
31
32
89
_2
5a
504b
504c
504g
504d
Display Cable
539
L
506
504f
504e
Battery
r_xm1a00_312359_313289_2a
Summary of Contents for XM PFP 273231
Page 46: ...Parts 46 3A8047B WL D...
Page 67: ...Notes 3A8047B 67 Notes...