Hopper Removal
Hopper
Hopper
Hopper Removal
Removal
Removal
To help prevent injury from suction, never place
hands near the pump fluid inlet when pump is
operating or when hopper is removed.
The hopper assembly allows easy detachment of the
hopper from the pump. To remove the hopper from
the pump, perform the following steps:
1.
Relieve pressure (see
Pressure Relief Procedure, page 21
).
2.
Unplug the power cord.
3.
Rotate knob (K) counterclockwise to loosen the
clamp between the hopper elbow and the lower.
4.
Remove the locking pin and pull down the hopper
latch (U) on the hopper plate.
NOTE:
NOTE:
NOTE: If needed, push down on the hopper
elbow to completely disengage from the pump
lower.
5.
Remove the two hopper pins (P) from the front
legs of the cart.
6.
Lift up on the handle and pull the hopper (J) away
from the sprayer.
NOTE:
NOTE:
NOTE: If the hopper elbow needs to be thoroughly
cleaned, rotate knob (K) to loosen the clamp between
the elbow and the hopper. Remove and clean the
elbow.
NOTE:
NOTE:
NOTE: To re-install the hopper, follow the steps
above in reverse order.
Shutdown
Shutdown
Shutdown
NOTICE
NOTICE
NOTICE
To prevent rust, never leave water or water-based
fluid in pump overnight.
To shutdown, flush the system (see
Flush, page 14
).
Lifting
Lifting
Lifting Instructions
Instructions
Instructions
When lifting the unit, only lift at the points indicated
by the arrows below.
22
3A3437F
