Setup
Setup
Setup
Setup
To avoid tipping over, ensure cart is on a flat and
level surface. Failure to do so could result in injury
or equipment damage.
1.
Turn the motor power switch (S) to OFF.
2.
Ground sprayer (see
Grounding, page 12
). Plug
the power cord into a dedicated circuit. See
Power Requirements, page 12
.
3.
Check Throat Seal Liquid (TSL) level in packing
nut (D). Fill 1/2 full with TSL.
4.
Connect air supply to applicator.
5.
Attach check valve (optional). Remove fluid
outlet assembly (F). Attach check valve (M) to
pump fluid outlet. Attach fluid outlet assembly to
check valve (M) outlet.
NOTE:
NOTE:
NOTE: If a check valve (M) is being used, it must
be installed between the fluid outlet assembly (F)
and the pump lower to ensure proper operation
of the pressure relief valve.
NOTE:
NOTE:
NOTE: Check valve (M) is intended for use
with low viscosity fluids such as water resistive
barriers.
6.
Attach hose to applicator fluid inlet and pump
fluid outlet (F), then secure Velcro straps (V)
around the cam fitting.
7.
Prime the system with water before using (see
Prime with Water, page 16
).
3A3437F
13
