Installation
12
311163ZAH
11. Uncrate and mount pumps to the ram plate (502),
with outlets facing away from pneumatic control
panel. Secure pumps to plate using the following
gaskets and hardware:
•
Part No. BESFxx and BESExx:
gasket (415),
screws (406), and washers (407)
•
Part No. BESAxx, BESBxx, BESCxx, and
BESDxx:
gasket (407), tri-clamp (406)
•
Part No. BES3xx and BES4xx:
gasket (407),
tri-clamp (406)
•
Part No. BES7xx:
screws (406), clamps (407),
and gasket (415)
12. For part numbers BES3xx, BES8xx, BES4xx, and
BESGBC install the two connecting rods (404) to
the ram plates. Secure with screws (405) and wash-
ers (411).
13. Install cylinder guide bearings (408) on top of the air
motor mounting plate (402), using screws (409) and
washers (410).
NOTE:
The open arch in the cylinder guide bearings
(408) fits around tie rods on the air cylinder (4).
14. Tighten lock nuts (7).
15. Using tubing (6), connect pneumatic control panel to
air motor air inlets.
16. On the control panel, switch to the RAM UP posi-
tion. Raise the ram and set the manual stop latch to
Engage position. See page 15. Remove the pallet
and any other shipping material.
F
IG
. 4: Air Motor Mounting Plate (BESA7A shown)
405, 411
26
4
602
408,
409,
410
402
502
18
20
19
6
404
R
TI16216a
TI16234a
Summary of Contents for SaniForce BES Series
Page 4: ...Models 4 311163ZAH ...