Installation
2
3A8507C
Installation
Set Up
Connecting to a Network
Summary
Please refer to the instructions in this section, unless
indicated otherwise.
1. Press and hold the button on the top of the Pulse
sensor until the LED light turns red.
2. Using a mobile device (e.g. laptop, smart phone,
tablet), search for a WiFi network beginning with
GRACO and connect.
3. Open a web browser and enter “192.168.4.1” into
the address bar.
4. After the WiFi settings page is loaded, select the
intended WiFi network from the drop down bar.
5. Enter the selected WiFi network password.
6. Click the Connect to WIFI button.
7. The LED on the Pulse sensor turns green (F
. 3).
8. Wait approximately 20 seconds.
9. The sensor flashes red or green several times.
• Green flashes indicate that a connection to the
network has been established.
• Red flashes indicate that a connection to the
network has not been established. The number of
red flashes identifies the problem:
NOTICE
• Do not over tighten TLM into tank bung. Over
tightening can cause permanent damage and
result in inaccurate readings.
• Do not use the TLM with pressurized tanks. Using
the TLM in a pressurized tank will damage the
TLM.
• Do not use thread sealant or adhesive. Many of
these products are chemically incompatible with
the ABS plastic threads.
F
IG
. 1
F
IG
. 2
F
IG
. 3
LED light
