Glossary of Terms
311189L
9
Mix
- when cross-linking of the resin (A) and catalyst (B)
occurs.
Modbus/TCP
- a type of communication protocol used
to communicate Digital I/O signals over an ethernet.
Network Station
- a means to identify a particular indi-
vidual proportioning or flow control system.
Overdose Alarm
- when either the resin (A) or catalyst
(B) component dispenses too much material and the
system cannot compensate for the additional material.
Potlife Time
- the amount of time before a material
becomes unsprayable.
Potlife Volume
- the amount of material that is required
to move through the mix manifold, hose and applicator
before the potlife timer is reset.
PreMix Dump
- refers to the time required to flush the
lines from the color or catalyst change module to the mix
manifold during a color or catalyst change.
PreMix Fill
- refers to the time required to fill the lines
from the color or catalyst change module to the mix
manifold.
Purge
- when all mixed material is flushed from the sys-
tem.
Purge Time
- the amount of time required to flush all
mixed material from the system.
Ratio Tolerance
- the settable percent of acceptable
variance that the system will allow before a ratio alarm
occurs.
Solvent Fill
- the time required to fill the mixed material
line with solvent.
Standby
- refers to the status of the system.
Third Purge Valve
- refers to the use of three purge
valves used to flush some water borne materials. The
valves are used to flush with water, air and solvent.
Flow Control Resolution
- a settable value that allows
the flow control system to maximize its performance.
The value is based on maximum desired flow rates.
V/P
- refers to the voltage to pressure device in the flow
control module.
