308783
11
Installation
b.
Connect an air line to the shut-off valve (J
-2
).
NOTE:
This line supplies the air to the control
solenoids and air driven power supply and to the
spray gun.
WARNING
COMPONENT RUPTURE HAZARD
To avoid component rupture and serious
injury, including injection, do not exceed
the maximum working pressure of the
system components.
The ProMix control has a 3000 psi (21 MPa,
207 bar) maximum working fluid pressure or
4000 psi (28 MPa, 276 bar) maximum working
fluid pressure with kit 239954 installed and 100
psi (0.7 MPa, 7 bar) maximum working air
pressure.
The solvent supply line inside the control has a
3000 psi (21 MPa, 207 bar) maximum working
fluid pressure. The fluid supply for solvent
purging must not exceed this maximum working
pressure.
8.
Connect the fluid supply lines to the ProMix control
connectors. See Fig. 1 and 3.
a.
Connect the component A (resin) line from the
fluid supply to control connector
A
.
b.
Connect the component B (catalyst) line from
the fluid supply to control connector
B
.
c.
Connect the solvent line from the fluid supply
to control connector
S
.
9.
Connect fluid and air supply lines to the spray gun.
See Fig. 1 and 4.
a.
Connect the gun fluid supply line (M) between
the manifold’s static mixer outlet (P) and the
gun fluid inlet.
Fig. 4
KEY
Gun Air Outlet
Air Signal Outlet (optional)
Alarm Air Outlet (optional)
Operator Station Connec-
tor
Printer Cable Connector
External Power Connector
P
Manifold Static Mixer Out-
let
7472A
P
