![background image](http://html1.mh-extra.com/html/graco/proguard/proguard_quick-start-manual_2251149002.webp)
Warnings
2
334371A
Warnings
The following warnings are for the setup, use, grounding, maintenance, and repair of this
equipment. The exclamation point symbol alerts you to a general warning and the hazard
symbols refer to procedure-specific risks. When these symbols appear in the body of this
manual or on warning labels, refer back to these Warnings. Product-specific hazard symbols
and warnings not covered in this section may appear throughout the body of this manual where
applicable.
WARNING
GROUNDING
This product must be grounded. In
the event of an electrical short circuit,
grounding reduces the risk of electric
shock by providing an escape wire for
the electric current.
This product is equipped with a cord having a
grounding wire with an appropriate grounding
plug. The plug must be plugged into an outlet
that is properly installed and grounded in
accordance with all local codes and
ordinances.
•
Improper installation of the grounding plug
is able to result in a risk of electric shock.
•
Check with a qualified electrician or
serviceman when the grounding
instructions are not completely understood,
or when in doubt as to whether the product
is properly grounded.
•
Do not modify the plug provided; if it does
not fit the outlet, have the proper outlet
installed by a qualified electrician.
•
Do not replace the cords of this device; if the
cord is damaged the device should be
properly disposed of.
•
This product is for use on a nominal 230V
circuit and has a grounding plug similar to
the plug illustrated in the figures.
•
Only connect the product to an outlet having
the same configuration as the plug.
•
Do not use an adapter with this product.
ti24426a
WARNING
EQUIPMENT MISUSE HAZARD
Misuse can cause death or serious
injury.
•
Before using this device make certain that the
total electrical load of your equipment does
not exceed the maximum rating of this device.
•
Do not alter or modify equipment. Alterations
or modifications may void agency approvals
and create safety hazards.
ELECTRIC SHOCK HAZARD
This equipment must be grounded.
Improper grounding, setup, or usage
of the system can cause electric
shock.
•
Turn off and disconnect power
cord before servicing equipment.
•
Connect only to grounded electrical outlets.
•
Use only 3-wire extension cords.
•
Ensure ground prongs are intact on power
and extension cords.
•
Do not expose to rain or wet conditions.
Store indoors.