Installation
312417F
3
Installation
1.
Connect air line inlet to port (15a) (F
. 1) on PAC.
2.
Connect pump air inlet to port (15b) (F
. 1) on PAC.
3.
Tighten fittings securely.
4.
Plug power cord in a grounded outlet.
Remote Mounting
Unless otherwise instructed, see F
. 1 for reference
numbers included in these instructions.
The PAC controller can be mounted in a remote, secure
location, away from the solenoid. The maximum dis-
tance the two components can be separated is 75 feet.
1.
If the PAC power cord is plugged into an electric out-
let, unplug power cord.
2.
Remove the 4 screws (7) from each corner of the
PAC cover and remove cover.
3.
Inside PAC control box, disconnect P1 SOL (white),
P2 SOL (black) and P3 GROUND (green) from ter-
minal block (See Wiring Diagram, page 7.)
4.
Loosen cord grip (6) and completely remove cable.
5.
Loosen screw (c) on the back of the mini DIN sole-
noid connection and disconnect solenoid.
6.
Remove screw (e) from front cover (f) on mini DIN
solenoid connection.
7.
Inside mini DIN solenoid connector, disconnect
black wire from terminal labeled 1, white wire from
terminal labeled 2 and green wire from GROUND
terminal.
8.
Loosen connector cord grip (d) and completely
remove cable.
9.
Replace cable with a longer cable (75 feet maxi-
mum), feeding one end through cord grip (6) and
into inside of PAC control box and the other through
cord grip (d) and into mini DIN solenoid connection.
NOTE:
a.
Replacement cable must be 18 AWG, pres-
sure extruded PVC jacket cable or hard usage
cord type “S” with STO standard PVC jacket
mini DIN solenoid
b.
Connector (d) (Part No. 121048) is required to
connect cable to solenoid.
10. Inside PAC control box connect P1 SOL (white), P2
SOL (black) and P3 GROUND (green) to terminal
block (see Wiring Diagram, page 7).
F
IG
. 1
15b
15a
ti11960a
7
(c)
6
5
(d)
(e)
(f)
(e) / (f)