![background image](http://html.mh-extra.com/html/graco/linelazer-iv-3900/linelazer-iv-3900_repair-parts-list-manual_2250945010.webp)
Auto-Layout Can Actuator Adjustment
10
312195B
Auto-Layout Can Actuator Adjustment
Adjustments
The can actuator is set at the factory. If the dot size is
not as desired, do the coarse and/or fine adjustments.
Coarse Adjustment
1
Locate four screws on side of holder base.
2
Loosen screws to allow holder base to move freely.
Do not aim aerosol can at your face.
3
Move holder base until solenoid cartridge bar is
approximately 0.10 in. (thickness of two dimes) from spray tip.
4
Carefully tighten screws. Verify gap.
Fine Adjustment
If coarse adjustment did not achieve desired dot size,
procede as follows:
1
Start striper and move to
PARKING MODE
display.
2
Set
DOT SIZE
setting to smallest size(least amount of bars
on display). Press arrow keys to increase/decrease size.
3
Do
Coarse Adjustment
steps 1 and 2. Move holder base
until a dot size of approximately a dime is achieved.
Tighten screws on holder base.
Note: Dot size consistency can vary due to weather
changes and differences in aerosol marking can brands.
ti10070a
ti10071a
ti10072a
ti10073a
MODE
SETUP
STALL SIZE 9.00’
0 mph
DOT SIZE
PARKING MODE
ti9919a
Good Dot
Poor Dot with Ghosting
ti10379a
ti10380a
Summary of Contents for LineLazer IV 3900
Page 37: ...Dimensions 312195B 37 ...