![background image](http://html1.mh-extra.com/html/graco/king-e50/king-e50_instructions-manual_2251568015.webp)
b.
Trigger gun into grounded pail. Pull out
pressure adjustment knob (H) and turn
clockwise slowly to increase pressure, until
a steady stream flows from gun. Push
knob in to lock. If flushing
flushing
flushing, trigger gun
until clean solvent flows from the gun.
c.
Engage gun trigger lock.
XTR
XTR
XTR Gun
Gun
Gun
XHF
XHF
XHF Gun
Gun
Gun
7.
If priming, equipment is now ready to spray
(proceed to
). If flushing, proceed
with step 8.
NOTE:
NOTE:
NOTE: The remaining steps are for flushing only.
NOTICE
NOTICE
NOTICE
Do not prime pump through drain/purge
valve using two component materials. Mixed
two-component materials will harden in valve
and result in clogging.
8.
Perform
9.
Turn power switch (E) ON.
10. To start pump, pull out pressure adjustment
knob (H) and turn clockwise slowly to increase
pressure, until a steady stream flows from drain
valve. Push knob in to lock.
NOTE:
NOTE:
NOTE: To determine the proper amount of
solvent and flushing time, remove the inlet
valve housing to verify it has been fully cleaned,
especially when spraying a new material for the
first time.
11. Wait for clean solvent to flow from drain tube.
12. Pull pressure adjustment knob (H) out and turn
counterclockwise until it stops. Push the knob
in to lock.
13. Turn power switch (E) OFF.
14. Perform the
.
3A8126B
15