37
1.
For ease of installation, extend LATCH
to its maximum length.
2.
Position base in vehicle seat as
shown.
3.
Thread LATCH through base belt
path normally used for vehicle
seat belt. Make sure that LATCH is
UNDER tongue on base
.
Belt must lay flat and not be twisted.
4.
Hook Connectors to vehicle lower
anchors. Pull firmly on Connectors to
be sure they are attached
.
5.
Tighten LATCH by pushing down
hard on base and pulling the
adjustment belt
.
6.
NEVER put two LATCH connectors on
one vehicle LATCH anchor unless
specifically allowed by the vehicle
manufacturer
.
7.
Test infant restraint for secure
installation as described in infant
restraint “Final Safety Check” p.40.
8.
Check that the LATCH stays tight and does not slip from the
tightened position. If it does not stay tight, try another
seating position or contact Customer Service.
6.4
Using LATCH to install Base
Tongue
Summary of Contents for ISPA010AB
Page 1: ...OWNER S MANUAL MANUEL D UTILISATEUR MANUAL DEL PROPIETARIO 2003 Graco ISPA010AB 08 03...
Page 32: ...U G 32 Notes Notas...
Page 33: ...33 Notes Notas...
Page 126: ...45 Notas...
