8.
Release the gun trigger once the system has
been sufficiently purged with air.
9.
Follow the
Pressure Relief Procedure, page 30
.
Prime
Prime
Prime the
the
the Isolation
Isolation
Isolation System
System
System
Use the following steps to load the system with paint,
change paint colors, or change from flushing fluid
to paint.
1.
Enter Prime mode
to empty any flushing
fluid or paint without refilling the isolation fluid
pump. See
2.
Supply the new paint to the fluid supply hose.
If using a color change equipped system, change
the spray preset to one using the desired color or
select a new color number if using Preset 0.
3.
Check and adjust the gun fluid pressure if
necessary. For example, adjust the pressure
down to avoid splashing while emptying the paint
into a container. Increase the gun fluid pressure
to speed up the priming process.
4.
Trigger the gun until new paint exits the gun. The
time that it takes to prime the system depends on
the length of hose and the fluid pressure.
5.
Enter Spray mode
. The isolation fluid pump
automatically fills. See
Spray
Spray
Spray with
with
with the
the
the Isolation
Isolation
Isolation System
System
System
Contact with the charged components of the spray
gun will cause an electric shock. Do not touch the
gun nozzle or electrode or come within 4 in. (102
mm) of the front of the gun during operation or
until performing the
.
Follow the
Fluid Voltage Discharge and Grounding
when you stop spraying and
whenever you are instructed to discharge the
voltage.
1.
Prime the isolation system. Follow
Prime the Isolation System, page 33
2.
Set the gun fluid settings. See
Adjust the Gun Fluid Settings, page 34
.
3.
Put the system into Spray mode
.
The isolation fluid pump automatically fills. The
light tower indicates the fluid level in the pump
as it fills or dispenses.
These set points can be customized in the
system settings on Pump Screen 1. See
Pump Screen 1: Pump Volume, page 54
.
Light
Light
Light
Definition
Definition
Definition
Green (solid)
The pump is 50% full or more.
Yellow (solid)
The pump is less than 50%
full but more than 10% full.
Red (solid)
The pump is less than 10%
full.
Note
To enter Spray mode, you must first be
in either Prime or Standby mode. You
cannot enter Spray mode directly from
Purge mode.
If color change is enabled, the system
remembers if it still has flush material
in the pump. The system will not allow
Spray mode to be entered until the pump
has been emptied in either Purge or
Prime mode.
3A8493A
33
