![background image](http://html.mh-extra.com/html/graco/high-production-series/high-production-series_operation_2250922053.webp)
Troubleshooting
3A3426EOperation
53
AUTO GUN MODE
Auto Gun won’t actuate when
the red button is pressed.
Gun is not activated.
Press the 1 or 2 button on control to activate a
gun.
Cable is not adjusted properly.
Adjust Cable to properly actuate gun trigger,
page 21.
Not on main striping screen.
Go to main striping screen on control to Actuate
Auto Guns.
Low Speed Shut off is enabled.
Disable Low Speed Shutoff, page 45.
Battery Voltage is too low.
Check battery voltage on Diagnostic Screen,
page 32, or with Volt meter. If below 11.5V,
charge battery or replace battery.
Cable is not adjusted properly.
Adjust Cable to properly actuate gun trigger,
page 21.
Red button is broken.
Test button functionality in Diagnostic screen,
page 32, replace if broken.
Auto Gun Cable is broken or extremely kinked
resulting in too much drag.
Replace Auto Gun Cable.
Solenoid wire is disconnected or broke.
Check Wiring Diagram, pages 57 & 59, repair or
replace wires if necessary.
Fuse to battery is removed or blown.
Check and replace fuse.
Solenoid is jammed.
Spray Lubrication on solenoid plunger.
Solenoid has failed.
Check resistance across solenoid wires.
Resistance should be between .2 and .26 ohms.
If it’s not, replace solenoid.
Control board has failed.
Replace Control board.
Line Spacing is not accurate
Wrong line pattern loaded.
Reload the correct pattern.
Machine is out of calibration.
Calibrate the machine, page 36.
Battery won’t stay charged.
Accessories are left on and drain the battery
when unit is not running.
Turn off accessories when machine is not in use.
Throttle is not set high enough.
Make sure engine is being ran above 3300 rpm
NO LOAD for proper power supply.
Power consumption from accessories is higher
than engine output.
Reduce accessories or charge battery when
necessary.
Wiring is broken or disconnected.
Check Wiring Diagram, pages 57 & 59, repair or
replace wires if necessary.
Charger is not working.
Check Charging state in diagnostics, page 33, to
see if charger is properly working. Replace
Board.
Auto Gun won’t shut off
Cable is kinked.
Repair or replace cable.
Solenoid is jammed.
Lubricate solenoid plunger, Check for solenoid
damage.
Needle in gun is clogged.
Clean out gun.
Problem
Cause
Solution
Summary of Contents for High Production Series
Page 25: ...Cleanup 3A3426EOperation 25 Standard Series ...
Page 26: ...LineLazer V LiveLook Display 26 3A3426EOperation LineLazer V LiveLook Display Standard Series ...
Page 56: ...Wiring Diagram 200HS Standard Series 56 3A3426EOperation Wiring Diagram 200HS Standard Series ...
Page 58: ...Wiring Diagram 200DC Standard Series 58 3A3426EOperation Wiring Diagram 200DC Standard Series ...