Quick Setup Guide
20
3A4676B
NOTE:
Programming instructions begin on page 21.
F
IG
. 19
DISPLAY
•
A blinking LED under HH, MM, SS
or ## identifies type of measurement
unit you are setting; i.e., HH is
hours.
•
A blinking number on the display
indicates the G3 is in SETUP
MODE.
•
In RUN MODE displayed numbers
count up or down. See Time ON and
Time OFF.
ON / BACKUP TIME
•
LED lights when ON
Time/Backup Time is running.
•
Display shows time as MM:SS
(minutes and seconds).
i.e., 08:30 is 8 minutes: 30 sec-
onds.
•
Sets the limits for the amount
of time to complete a cycle
before an alarm warning is
activated.
•
Counts down from a set time to
zero.
OFF TIME
•
LED lights when OFF Time is
used to control Pump OFF func-
tion.
•
Value is entered in HH:MM (hours
and minutes) or HHHH (hour,
hour, hour, hour) when A8 is on.
•
Displays in HH:MM (hours and
minutes) when > 1 hour.
•
Times pump rest between lube
events.
•
Counts down from set time to
zero.
ALARM ICONS
LED next to icon lights when a
fault / warning event occurs
during a run cycle. See page 32
for a complete description of
these alarm scenarios.
PIN ICON
•
LED next to icon lights indi-
cating PIN is required to
enter setup.
•
In SETUP MODE LED
lights when setting up the
PIN.
LEFT DIRECTION ARROW /
RESET
•
In SETUP MODE: moves cursor
in display one field to the left.
•
In RUN MODE: single press
clears warning.
•
In RUN MODE: pressing for one
second ends run cycle if no
warnings.
•
In ALARM MODE: pressing and
holding for 3 seconds clears
fault / warning and switches
cycle to OFF MODE.
RIGHT DIRECTION ARROW /
MANUAL RUN / ENTER
•
In SETUP MODE: saves
entry, moves cursor in display
one field to the right or to the
next setup step.
•
In RUN MODE: starts a man-
ual run cycle.
UP and DOWN ARROW
•
Hold both the UP and DOWN ARROW but-
tons down together for 3 seconds to enter
SETUP MODE.
•
In SETUP MODE: increases or decreases
number values shown in display.
