Quick Setup Guide
3A4676B
21
Programming
Program the controller to set up the number of cycles
(ON) and a timed OFF Time/Rest period.
By default, the number of the lubrication cycles pro-
grammed is 1 and the backup time between cycles is 4
minutes. The OFF/Rest Time is 2 hours.
If the unit powers-up in ON mode and has
not been primed, hold the reset button
(shown on the right) for 1 second to
change to the OFF mode.
NOTE:
•
A blinking number on the display indicates the G3 is
in SETUP MODE.
•
In ON/Cycle MODE numbers on the display do not
blink.
•
After 60 seconds of no activity, the device returns to
OFF/Rest Time and the OFF Time restarts counting
down from the total programmed amount of time. It
does
not
resume the countdown from the point
where the cycle was interrupted when you entered
SETUP MODE.
Entering Setup Mode
Press both the UP and DOWN
ARROW buttons together for 3
seconds to enter the SETUP
MODE.
NOTE:
If the lock LED is
lit after entering Setup
Mode and four 0000’s
are displayed, the unit
has a PIN Code lock out
enabled. See the follow-
ing section: Entering a
PIN Code to Access
Setup Mode.
Entering a PIN Code to Access Setup Mode
The G3 controller does not require a user to provide a
PIN code to access the programming features of the
unit. However, Graco understands that some users may
want to protect the programming settings and therefore,
an option for adding PIN Code authorization is available.
The instructions for setting up PIN Code Authorization
are provided in the Advanced Programming section of
this manual. See page 25.
To enter the PIN Code:
1.
Press both the UP and
DOWN ARROW buttons for 3
seconds.
2.
The LED next to the LOCK ICON on
the display lights and the 4 zeros
appear on the display indicating the
system requires a PIN Code entry to run the G3 in
SETUP MODE.
3.
The cursor is automatically
positioned to enter the first
character of the PIN Code.
Use the UP and DOWN
ARROW buttons to move up
and down through the numbers 0-9 until the first
number in the PIN code is displayed in the field.
4.
Press the ENTER button to set the num-
ber. The cursor automatically moves to
the next number field.
5.
Repeat steps 3 and 4 for each PIN Code prompt
field.
If the PIN Code you entered is correct, the first editable
character on the display will flash.
NOTE:
A blinking field on the display indicates the G3 is
in SETUP MODE. In RUN MODE numbers on the dis-
play will not blink.
Cycle Setup
Cycle controls the number of lube cycles (as monitored
by an external cycle monitor) completed before the
pump rests.
NOTE:
•
You must program at least
one
cycle. Zero is not an
available option.
•
The first number dis-
played after the “CY”
on the display blinks,
indicating the device
is ready to program
the number of cycles.
