![background image](http://html1.mh-extra.com/html/graco/compact-twin-flow/compact-twin-flow_manual_2251530010.webp)
10
SHOT FLOW screen continued
For more information on the use of these buttons see the Daily Operation Section of this manual.
START CYCLE button
This button will activate the machine to run the pre-selected sequence defined in this screen.
SHOT SIZE (cc’s) button/indicator
This button/indicator shows the volume setting of the material of the SHOT SIZE volume in cubic centimeters
(cc’s).
To change the SHOT SIZE volume, do the following:
1.
Select SHOT SIZE button, a numeric keypad should appear.
2.
Enter in the material shot size volume as required.
3.
Press the ENTER button.
4.
The new shot size volume should appear in the SHOT SIZE indicator.
FLOW RATE (cc’s/sec) button/indicator
This button/indicator shows the volume setting of the material FLOW RATE
volume in cubic centimeters (cc/sec).
To change the FLOW RATE volume, do the following:
1.
Select FLOW RATE
button, a numeric keypad should appear.
2.
Enter in the material flow rate volume as required.
3.
Press the ENTER button.
4.
The new shot size volume should appear in the FLOW RATE
indicator.
RUN SETUP PROGRAM button
When this button is selected a factory preinstalled setup program will upload into the CTC Parker Automation
memory. Included in this setup program are various setup parameters that were previously installed by the factory or
by the operator.
RUN MAIN PROGRAM button
When this button is selected a factory-preinstalled program will upload into the CTC Parker Automation memory.
This program will give the machine the various instructions to perform the actual operations.
For more information on the use of these buttons see the Daily Operation Section of this manual.
SERVO POWER ON button
This button connects electrical power to the machines’ servomotor material pump.
SERVO POWER OFF button
This button disconnects electrical power to the machines’ servomotor material pump.
SERVO ENABLE ON button
This button enables the machines’ servomotor to drive the material pump.
DRIVE ENABLE button
This button enables the machines’ drive run material pump.
RESET SERVO button
This button will reset the machines’ servomotor to drive the material pump.