![background image](http://html1.mh-extra.com/html/graco/35-elite/35-elite_instruction-manual_2249990066.webp)
6 V
ehicle
Information
66
How to Lock Your Lap/Shoulder Vehicle Seat Belt
Note:
With the vehicle seat belt in
this locking mode, all the tension
is upwards in the shoulder belt.
This may start to tilt your car seat
sideways when rear-facing. If
this happens, use a locking clip
instead of switching the retractor.
See Sliding Latch Plate and ELR
Retractor.
Sliding Latch Plate
and Switchable
Retractor
A latch plate that slides
freely on the belt webbing
and cannot, by itself, hold
the belt snug around a car
seat.
When installing the car
seat, route the vehicle seat
belt through the proper
belt path and buckle it in.
Slowly pull the shoulder
belt all the way out
to switch it to locking
mode.
Then, as you pull
the vehicle seat belt tight,
feed all the slack back into
the retractor.
Grab the sides of the base
or seat at the belt path and
slide side to side and front
to back. The base or seat
should not move more
than 1” (2.5 cm).
Note:
When using the base,
you do not need to switch the
retractor. The lock-off locks the
seat belt.
Summary of Contents for 35 ELITE
Page 78: ...78 NOTES...
Page 79: ...79 NOTES...