Graco 26A530, Instructions Manual

Page: 6 / 24

Setup
6 3A5278B
Setup
Fieldbus Configuration Screens
The fieldbus screens are shown only if a CGM is
connected to your system. Find your fieldbus type in the
following table to identify parameters you can view or
edit.
1. Access the fieldbus screens from the setup mode
screens.
2. Turn setup key to enter Setup Mode.
3. Press to go to system setup screens.
4. Press multiple times as needed to go to
fieldbus screens.
NOTE: The fieldbus screen will not display if CAN
cables are not connected. Ensure that all CGM CAN
cables are connected.
PROFIBUS Fieldbus Screens
Screen 1
This screen enables you to set the hardware revision,
system serial number, device address, and installation
date.
Fieldbus Screens Page
PROFIBUS 6
PROFINET 7
DeviceNet 9
EtherNet/IP 10
F
IG
. 3: PROFIBUS Fieldbus Screen 1
Parameter Range
Hardware
Revision 0-9999
System Serial # 00000000-99999999
Device Address 000-126
Install Date Set as required. Use format shown in
figure above. Validate date and time
before saving.