Graco 26A530, Instructions Manual

Page: 10 / 24

Setup
10 3A5278B
EtherNet/IP Fieldbus Screens
Screen 1
This screen enables you to set the hardware revision,
system serial number, and the IP address.
Screen 2
This screen enables you to change settings for DHCP,
Subnet Mask, Gateway, DNS 1, and DNS 2.
Screen 3
This screen lists identification information for the
Datamap that has been loaded into the CGM.
F
IG
. 12: EtherNet/IP Fieldbus Screen 1
Parameter Range
Hardware
Revision
System Serial #
IP Address Required at installation
F
IG
. 13: EtherNet/IP Fieldbus Screen 2
Parameter Range
DHCP
Yes or No
Subnet Mask Set as desired
Gateway Set as desired
DNS 1 Set as desired
DNS 2 Set as desired
F
IG
. 14: EtherNet/IP Fieldbus Screen 3