Repair
22
3A8570B
4. Push the four screws (10) through the adapter plate
(2) and use a 1/2 in. socket wrench to tighten
(Torque 30 ft-lbs, 40.7 N•m) (see F
5. Put the pump housing assembly onto the motor.
The motor shaft key should match the slot on the
gear on the inside cover. The pump outlet should
face up and the terminal box should be centered
between the pump outlet and the pump inlet (F
. 33).
6. Place and tighten the four Allen screws (6) using an
5/16 in. (8 mm) hex wrench (Torque 20 ft-lbs, 27.1
N•m) (see F
7. Push the pressure switch wire into the wire clamp
and into the terminal box through the strain relief
(see F
8. Twist the strain relief nut on using a wrench until
tightened (see F
9. Crimp the fork connector to one of the pressure
cable wires (see F
. 32).
10. Connect the crimped wire to E1.
11. Reinsert the second wire back into the connector
containing the yellow and white cables (F
F
IG
. 29
F
IG
. 30
Notches
Pump Inlet
F
IG
. 31
Motor Shaft Key
Gear Slot
