![background image](http://html1.mh-extra.com/html/graco/24x960/24x960_operation_2251504018.webp)
Reinstall
Reinstall
Reinstall Electronics
Electronics
Electronics Cover
Cover
Cover onto
onto
onto Driver
Driver
Driver (only
(only
(only
ifif
if removed
removed
removed to
to
to replace
replace
replace the
the
the encoder
encoder
encoder cable)
cable)
cable)
Make sure wires are not pinched when re-installing
covers. Wires will be damaged and create an
electrical hazard and/or fire and explosion hazard
if pinched.
1.
Plug in all connectors. Ensure all connectors
are securely attached to the control board (see
).
2.
Secure loose motor wires into the clip inside the
housing (see
).
3.
Reinstall electronics cover onto center housing.
4.
Install the 12 bolts using a 6 mm hex wrench.
NOTE:
NOTE:
NOTE: Ensure the lock washers are still in place.
5.
Torque the bolts to 15 ft-lb (20 N
•
m).
Reinstall
Reinstall
Reinstall Motor
Motor
Motor Cover
Cover
Cover
1.
Reinstall motor cover onto driver housing.
2.
Install the four bolts and mounting lock washers
that hold on the motor cover using a 6 mm hex
wrench. Ensure the lock washers are still in
place.
3.
Torque the bolts to 15 ft-lb (20 N
•
m).
4.
Follow the
Reattach
Reattach
Reattach Pump
Pump
Pump Lower
Lower
Lower
See the system manual.
18
3A8124A