Operation
3A0232E
21
Adjust Anvil to Idler Tension
To adjust the anvil (AC) to idler (AJ) tension, the idler
position can be adjusted.
1.
Follow
Pressure Relief Procedure
, page 22.
2.
Engage trigger lock.
3.
Loosen knob (528) then remove cover (527). See
page 42.
4.
Loosen idler cap screw (617) using 3/16 in. hex key.
5.
Slide idler to desired position.
6.
Tighten idler cap screw to lock idler in position.
Blower Air Adjustment
The cutter has blower air to help keep the anvil cool and
to keep the inside of the cover free of debris. The blower
air has been factory set to optimize performance of the
cutter, however it can be adjusted.
Use a 3/32 hex allen key to turn adjusting screw (635)
counter-clockwise to allow more air flow into the inside
of the cover on the cutter assembly. This will affect air
motor performance as less air will go to the air motor
resulting in slower cutter speeds. See
on page 42 for adjusting screw location.