Graco 248113, Instructions Manual

Page: 3 / 6

Installation
309930C 3
Installation
Use F
IG
. 2 for the following instruction.
1. Install 12-gauge red wires #1750 and #1730 into
new connector (J).
2. Once pins are inserted, install clamp to hold pins to
connector.
3. Cut 2 in. off both wires (O, P).
4. Strip 9/16 in. of insulation with 12-gauge wire
stripper.
5. Inspect wires. If not black or in burnt condition,
continue to step 6. If wires appear black or in burnt
condition, repeat steps 3 and 4. Do not exceed 6 in.
7. Install splice onto the strands of each wire. Tighten
screw terminal onto each wire.
9. Slide shrink tubing over splices.
10. Using a heat gun or hair dryer, heat shrink tubing
around splice. If neither is available, wrap entire
length of shrink tubing with electrical tape.
11. Connect 2-pin black plastic connectors together.
F
IG
. 2: Installation of new harness
H
J
K
To white
terminal block
To circuit board
Red wires
TI5690A
6. Install shrink tubing over both wires.
Shrink tubing Transformer
D
C
8. Insert wires (O, P) into other end of splice and
tighten.
Shrink
tubing
Splice
Transformer
O
P
2-pin black
connector
D
C