1. Rotate the hand wheel in the back of the
machine until the Needle Bar is in the lowest
position. Loosen screw inside sewing machine
head using a flat head screw driver.
2. Place the Needle Bar Height Spacer into the
Bobbin Case area.
3. Using a Needle Bar Height Spacer bring the
Needle Bar down till the tip of the Needle is
resting on the flat surface of the Needle Bar
Height Spacer.
4. Tighten the screw inside the head of your
machine with a flat head screw driver, make
sure the Needle Bar is facing forward so the
thread guide is in the front of your machine.
Adjust Needle
Bar height with a
Flat Head Screw
Driver here.
*Note: Display Board Box may
have to be removed to access.
Thread Guide
faces front
of machine
Needle
Bar Height
Spacer
Tighten
Screw inside
this hole
Height
Spacer
Flat Spot
Tip of
Needle
Tools Needed:
Flat Head Screwdriver
Needle Bar Height Spacer
|
Needle Bar Height
Q’nique 21: Service Manual
3
Summary of Contents for Q'nique 21
Page 1: ...Service Manual 21 ...
