Gotting HG G-71450-A, Manual

Page: 21 / 78

Device Description HG G-71450/1/3/5-A | English, Revision 02 | Date: 06.06.2019
21
Hardware – Chapter 3
3.2.4.2 LEDs
5 LEDs are provided for function control:
3.2.4.3 Data Interface CANopen®
In case of this antenna, the data and a status byte are emitted via the CAN bus. Fur -
ther information on the CANopen® interface and on setting the CAN Node address -
es via the Hex-turn-switch can be found in chapter 7 on page 35.
3.2.4.4 RS 232-Interface
The RS232 interface is used for logging and for the internal monitor program for
configuration, see chapter 9 on page 49.
3.2.4.5 PosiPulse Filter
For this antenna variant, a filter for the PosiPulse can be set for slow vehicles, see
section 9.4.3.2 on page 54.
Table 11
HG G-71453: Pin assignment of the 5 pin circular connector ST2 (socket)
ST2, female, A-coded Pin Assignment
1 n. c. *)
2 n. c. *)
3 CAN_GND
4 CAN_H
5 CAN_L
*)
The pins 1 or 2 are connected between ST2 and ST3.
Table 12
HG G-71453: Pin assignment of the 5 pin circular connector ST3 (pin)
ST3, male, A-coded Pin Assignment
1 n. c. *)
2 n. c. *)
3 CAN_GND
4 CAN_H
5 CAN_L
*)
The pins 1 or 2 are connected between ST2 and ST3.
Table 13
Meaning of the 5 LEDs
LED Meaning
PWR indicates that operating voltage is available
CD permanently lit when a transponder is in area I (see Figure 2 on
page 13)
DATA – flickers when a transponder approaches (area II in Figure 2 on
page 13)
– permanently lit when the transponder is read reliably
POS corresponds to the positioning output
BUS – permanently lit in „operational“ state
– blinks in „pre-operational“ state
– flashes in „stopped“ state
– does not light up in case of CAN bus errors
1
2
3
4
5
1
2
3
4
5