Device Description HG G-71450/1/3/5-A | English, Revision 02 | Date: 06.06.2019
54
Chapter 9 – Software / Configuration
9.4.3 Monitor Program HG G-71453
9.4.3.1 Main menu
Figure 22
HG G-71453: Main menu of the monitor program
The top line shows the operating frequency (variant -Z: 409 kHz, variant -Y: 125 kHz),
the code of the last received transponder in hex or decimal and the status. For the
coding of the status bits see Table 35 on page 38.
The CAN bus status is displayed in the line below. CAN online changes to CAN offline
if e. g.
the CAN bus connector is unplugged.
the CAN controller enters the BUSOFF state due to a missing terminating resis
-
tor (a suitable terminating resistor is available as an accessory, see Table 3 on
page 10)
In addition, the CANopen® node state is displayed (stopped, preoperational oder op
-
erational).
The internal status should normally always be
0000
.
: Parametrisation of a filter that can prevent the premature triggering of a position
-
ing pulse in very slow vehicles, see section 9.4.3.2 on page 54.
: CAN configuration, see section 9.4.3.3 on page 55.
By entering
changed parameters are stored in the EEProm. With
default val
-
ues are stored in the EEProm. By entering
the monitor mode is exited.
9.4.3.2 (P)osi Filter
The PosiPulse filter defines a time period in ms for which the DATA signal must be
omitted at least before the positioning pulse is triggered. With the help of this filter,
problems caused by positioning pulses triggered too early when entering the tran
-
sponder field can be solved at very slow travel speeds.
At high driving speeds it can occur that the PosiPulse is not triggered in the signal
gap but only when leaving the detection area. Please also note that this will shift the
location of the positioning by the distance covered within the set time.
HG 71453 Monitor
System: 409 kHz / Code [hex-dez]: 1111 - 4369 / Status: 60
Node ID [hex]: 02 / CAN offline : / int.Status: 8801
(H)ex Input Transponder Code [0..FFFF]: 0000
(D)ez Input Transponder Code [0..65535]: 0000
(W)rite Transponder
(P)osi Filter [0..255 ms]: 0
(C)AN Menu
(L)oad Values to EEProm
(V)ersion
(U)pdate Firmware
Default Values to (E)EProm
(Q)uit
