Software
Englisch, Revision 14, Date: 07.02.2017
32
Other menus are activated by pressing the (characters in brackets). Before altered
values are transferred into the permanent memory, the pass word
815
has to be en-
tered by pressing
. This prevents unintended alterations of values. With
the val-
ues are saved after their alteration and input of the password.
System status are explained in plain text upon pressing
. Typing
deletes the error
display. Quit the menu by pressing
.
The following sections describe one by one the menus
-
(
)ime & Code (section 5.2.2.2 on page 33)
-
(
)erial Output (section 5.2.2.3 on page 34)
-
C(
)N Parameters (section 5.2.2.4 on page 36)
-
P(
)ofibus-Parameters (section 5.2.2.5 on page 37)
-
CS(
) (section 5.2.2.6 on page 38)
-
(
)oot Load (section 5.2.2.7 on page 38).
-
(
)uit Monitor. With
the monitor program is left, whenever the serial proce-
dures 3964R or transparent are active. In procedure ’Monitor only’ it is impossible
to leave the monitor program.
E
System status expression in hexadecimal notation. The single
bits are explained in Table 9 „Possible system status mes-
sages“ on page 21.
N
Number of reading errors per transponder crossing. This value
is stored until a new transponder has been detected.
Ftx
Display of the transmission frequency divided by 128. This fre-
quency is permanently monitored and considered for the sys-
tem status word.
Prog_Code
Code to be programmed into the Transponder.
Description of the system variables
Table 20
Description of the system variables (monitor program) (Abschnitt 2 von 2)
