App Setting
1. Can the apps be used by more than one user?
Yes. Operation steps are as below:
1. The administrator(who is first use the APP) should firstly store all
phone number list that will use the APP.
2. Second user also need to create your account, when you entered
into the APP interface, you should store the phone number of the
first person's.
3. The third person should done so as step 2.
2. When programming on the mobile apps, there's no reply from the
control panel.
Control panel reply every programming, users have to wait the SMS
REPLY and then do the next step.
52
1. Why PIR Motion Detector beeps without detecting intruders?
If PIR Motion Detector beeps, and LED indicator flashes continuously,
the detector is in low battery. Please change the battery immediately.
2. Why PIR Motion detector does not detect movement?
A.
Please make sure the control panel is in arming status, not at stay
(home)mode or disarming status.
B.
Please make sure the LED of PIR motion detector lights up when you
walk in the detection area.
C.
Movement should cross the detection and within 8 meters range.
D.
The detector enters sleeping mode to save power after first detection. If
there's no movement within 4 minutes, the detector goes back to the
working state. If there's detection occurs within 4 minutes, the time detector
goes back to working state will be added accordingly.
3. If the PIR motion detector pet-immunity?
No. The PIR supplied in standard kit is normal PIR. If you have pets at home,
please adjust the installing height to allow your pets to roam below the
mounting height of the unit without causing alarms.
4. There’s no one passerby the room, but the detector trigger the alarm
A.
Check if there's any pet at home, the PIR supplied in the standard kit is
normal one, not pet-immune one.
B.
Please avoid mounting the P.I.R. motion detector at the place where
rapid heat changes such as window, air conditioner, light, electric heater,
refrigerator, oven, stove etc.
C.
Avoid strong sunlight.
D.
The installation height and range should be in the detection area.
PIR Motion Detector
E.
Make sure the insider battery contact well or not.
F.
Check the board put well or not.
G.
If zone jumper is changed, please enroll the sensor to the system again.
53
