110°
2m
4m
6m
8m
0m
0m
2m
1. Avoid mounting the detector close to places where heat changes fast
or air stream flows frequently. (ie. Air conditioner, tube light, oven, waver,
refrigerator etc.)
2. Avoid it facing to window which can be easily interfered
by complicated environment. (ie. sunlight, crowds, or
flowing cars etc.)
3. The product can reduce the possibility of accident,
but the user is advised to take all necessary precautions
for the safety and the protection of the property.
Detection Area
Side View
Top View
Connecting P.I.R. Motion Detector to Control Panel
The new-bought P.I.R. motion detector should be enrolled to the control
panel before use. For specified operation, please refer to the manual of
alarm system.
Notice
Walk Test:
1. When the power is on, the LED indicator flashes five times
and buzzer beeps five times to enter working state.
2. Walk across detection area and watch the LED indicator
to make sure it flashes once when detecting the
movement. After one detection, it will detect once every
one minute.
1
4
3
2
6
2.0~2.2m
5
Installation:
1. The motion detector should be installed in entry or exit which
intruder can easily enter.
2. The detector is more sensitive to cross-movement than to direct
movement. The performance of the detector is optimal when
detection direction is across the walking direction of intruders.
3. Press the clip, insert the battery properly, and then close the cover.
4. Using screws to fix the bracket of detector on the wall, attach the
detector to the bracket.
5. Keep LED indicator at the right direction. The fixing height isabout
2~2.2m from the ground.
6. Adjust installation height or bracket to change the detection
distance and angle.
Installation & Walk Test
Testing Mode:
When the power is on, the LED indicator flashes 5 times,
and buzzer beeps 5 times to enter testing mode after 40 sec preheat.
In the test mode, it will enable the LED indicator to light and control panel
to alarm every time once a movement is detected. After the 20th detections,
LED lights light up 2 times to indicate that it is going to enter into sleep mode.
Sleeping Mode:
The sleeping time of PIR approximately 4 minutes to save
power. No movement detected within 4 minutes, the PIR detector goes back
to the working mode. Once PIR is triggered, the PIR will light in red and alert
alarming. PIR will re-enter into sleep mode after 3 times detections during
the working mode. Any movement detected within 4 minutes , the PIR will
not light in red and the alarm will not be activated. And it will extend the
sleep time by another 4 minutes.
19
18
