TORQUE WASHER
3/8" WASHER
(UPHILL) GROUND. IF INSTALLING ON A RELATIVELY
CARRIAGE BOLT
LEVEL SURFACE, THIS HOLE WILL NOT BE USED.
BOLT CAP
3/8" LOCK NUT
THE HOLE ABOVE WHERE THE SWING BEAM MOUNT
IS POSITIONED IS TO BE BE USED ONLY ON UNEVEN
3/8" X 6-1/2"
SWING BEAM MOUNT
STEP 19: ATTACHING THE SWING BEAM MOUNT
1: THE 4 X 4 X 47-1/2" SWING BEAM MOUNT HAS COUNTER-SUNK HOLES IN THE CENTER AND ON THE ENDS. INSTALL
THE SWING BEAM MOUNT SO THAT THE COUNTER-SUNK HOLES ON EACH END OF THE BEAM FACE OUT, AND THE
COUNTER-SUNK HOLES AT THE CENTER FACE DOWN.
2: FASTEN THE SWING BEAM MOUNT TO THE CORNER POSTS USING 3/8" X 6-1/2" CARRIAGE BOLTS WITH TORQUE
WASHERS. PLACE THE CARRIAGE BOLT INTO THE TORQUE WASHER, THEN INTO THE HOLE OF THE CORNER POST
AND SET WITH A HAMMER. USE 3/8" WASHERS AND LOCK NUTS TO SECURE THE SWING BEAM MOUNT FROM THE
OUTSIDE. PLACE BOLT CAPS OVER THE EXPOSED THREADS AFTER SECURING.
47