Gorilla Playsets 1500GWF, Manual

Page: 57 / 177

STEP 2: ASSEMBLING THE RIGHT SIDE FRAME
1: LAY THE RIGHT SIDE CORNER POSTS ON THE GROUND IN THEIR PROPER ORIENTATION.
2: LAY THE 2 X 6 X 78" SIDE SANDBOX BOARD- RIGHT ON TOP OF THE RIGHT SIDE CORNER POSTS AT THE BOTTOM
OF THE CORNER POSTS. THE HOLES IN THE SIDE SANDBOX BOARD - RIGHT MUST BE OFFSET DOWN.
.
3: USE 5/16 X 4-1/2" HEX BOLTS AND 5/16" WASHERS TO ATTACH THE TOP HOLES OF THE SANDBOX BOARD TO THE
T-NUTS INSTALLED ON THE CORNER POSTS. THE BOTTOM HOLES WILL BE USED LATER.
4: LAY THE 2 X 6 X 47-1/2" BOTTOM PANEL BOARD ON TOP OF THE RIGHT SIDE CORNER POSTS IN THE MIDDLE OF
THE CORNER POSTS. THE HOLES IN THE BOTTOM PANEL BOARD MUST BE OFFSET DOWN.
5: USE 5/16 X 4-1/2" HEX BOLTS AND 5/16" WASHERS TO ATTACH THE BOTTOM HOLES OF THE BOTTOM PANEL
BOARD TO THE T-NUTS INSTALLED ON THE CORNER POSTS. THE TOP HOLES WILL BE USED LATER.
6: LAY THE 4 X 4 X 47-1/2" SWING BEAM MOUNT ON TOP OF THE RIGHT SIDE CORNER POSTS. THE THREE
COUNTERSUNK HOLES IN THE MIDDLE OF THE SWING BEAM MOUNT MUST FACE DOWNWARD.
7: FIND TWO TORQUE WASHERS. PLACE A 6-1/2" CARRIAGE BOLT THROUGH THE TORQUE WASHER, MAKING SURE
THAT THE TEETH ARE FACING IN THE SAME DIRECTION AS THE THREADS OF THE CARRIAGE BOLT. PLACE THE
TORQUE WASHER/CARRIAGE BOLT ASSEMBLY INTO THE CORNER POST HOLES SO THAT THE HEAD OF THE
CARRIAGE BOLT FACES WHAT WILL BE THE INSIDE OF THE FORT. USE A HAMMER TO SET THE TORQUE WASHER INTO
THE CORNER POST.
8: ATTACH THE SWING BEAM MOUNT AS SHOWN IN DETAIL A.
THE THREE COUNTERSUNK
HOLES ON THE
SWING BEAM MOUNT
WILL FACE DOWN WHEN
PROPERLY INSTALLED.
BOLT
TORQUE WASHER
3/8" WASHER
3/8" NUT
DETAIL A
6-1/2" CARRIAGE
BOLT CAP
5/16 X 4-1/2"
2 X 6 X 47-1/2"
5/16" WASHER
OF FORT
HEX BOLT
RIGHT SIDE
(OFFSET HOLES DOWN)
SWING BEAM
BOTTOM PANEL
MOUNT
BOARD
4 X 4 X 47-1/2"
(OFFSET HOLES DOWN)
2 X 6 X 78"
SIDE SANDBOX
BOARD-RIGHT
FRONT OF FORT
A
46