Gorenje H 30 DV, Instruction Manual

Page: 14 / 27

14
Only put water in the water tank. Never put any
additives, e.g. inhalants or essential oils, in the
water tank.
5. Put the tank cap back on the water tank (10)
and turn the tank cap clockwise (8) until it is
tightly locked.
6. Put the water tank back onto the base and
carefully align it in its original position on the
base.
Water starts running into the water basin right
away.
7. Put the tank cover back onto the water tank.
You can rotate the tank cover to place the mist
outlet in the required position.
8. Put the mains plug in the wall socket.
Do not use an extension cord.
Display

“On/off” button:
When plug on there will be the buzz for notice and
the unit is under the condition of ready work .
when you press the on/off button, the unit start to
work with the biggest humidity output and the
normal on.

»MODEL« button:
There are 3 modes. Keeping on pressing the
button, it will cycle as follows:
“normal” mode;
Under this model, humidity could not be set. But
the humidity output could be adjusted.This is the
default mode of the unit.
“auto” mode;
The unit is working by set humidity level. The
humidity output could not be adjusted under this
mode.
“sleep” način;
Under this mode, there is no sound when pressing
the button and the unit is working on second
speed. Also the display turn off in the few
seconds.

“HUMIDITY” button:
When the unit is working on non-Normal mode,
the unit is ready to mode setting. The default
humidity is 55%. Keeping on pressing the button,
the humidity setting will cycle as follows:
Notice:
1. When the unit is working under Normal mode,
after putting the humidity set button,the unit
will switch to Auto mode. Keeping on pressing,
the humidity setting will cycle as above.
2. When the set humidity is 2% higher than the
environment humidity, the unit works normally.
When it is less than 3%, it stops work.

»HEATER« button:
Press this key and the heating is on at the same
time the icon on the display screen light up. If you
press again on mentioned button, the heating will
turn off.

»TIMER« button:
Press this key to adjust the time :
Max. setting time for timer is 12 hours.

»SPEED« button:
When unit is working under Normal mode, after
pressing this button, the unit will switch to
Humidity Setting mode. Continue to press this
button,the humidity output will cycle as follows: