PROGRAM MODE
Overview (Software Version R1.07.6)
Program Mode is used to control and adjust all of the features on the Q and iQ series G-Force®. Before
entering Program Mode review the
Program Mode Menu outline, Chart D, pages 30-35.
Note:
Force Sensing Handles are not supported on units running software version R1.07.2 or earlier.
Contact Gorbel for information on software updates.
Using Program Mode
Program Mode is initiated by following the steps below. Reference
diagrams B
and
C
on page 22 for
button locations.
Entering Program Mode (
chart A
, page 27):
1.
Press and Hold
the MENU button (right-hand side of handle) for two seconds to activate Program
Mode.
2. After two seconds, release the MENU button. The red and blue LEDs will illuminate and “PROGRAM
MODE” will be displayed for one second. Then the first menu will be displayed.
• Q unit: SPEED MENU (default).
Note:
If the Virtual Limits Package has been ordered, the Virtual
Limits Menu (V-LIMITS) will appear first.
• iQ unit: V-LIMITS MENU
3. Press the MENU button to toggle between menus. The LCD will display the corresponding
programmable menus:
• V-LIMITS MENU - Virtual Limits menu (
option
)
• SPEED MENU - Lift Speed adjustment
• RESPONSE MENU - Lift Response (acceleration) adjustment
• SETTINGS MENU - Programmable Features on both the Q and iQ units
• SETTINGS MENU 2 - Programmable Features on iQ units only (
iQ only
)
• LED MENU - Program the LED lights (
iQ only
)
• SERVICE MENU - Customize and manage maintenance and service features
• CONFIGUR MENU - Special unit features and hardware configurations
4. Once you have reached the menu you would like to enter, press the G-Force® logo button.
5. The first programmable feature in that menu will be displayed.
Chart D
, pages 30-35, displays a full
list of all the menus and programmable features under each menu.
6. To move to the second programmable feature press the G-Force® logo button again.
7.
Note:
If the MENU button is pressed after Step 4, the selection is cleared and the LCD displays the
next program menu.
8. Once the desired feature is selected wait three seconds.
9. After displaying the feature text for three seconds, the request is executed. The LCD will flash the
feature text several times to indicate the command is being executed.
10. After the command is executed, the system returns to standard operation, and the LCD displays “LIFT
READY”.
25
9/18 - Rev. U
