12.
TROUBLE SHOOTING
Error Code
Meaning
Problem
Solution
Err(or E00)
No Safety key on Panel
Safety key is not on
the panel or it is not
properly put on
1. Put safety key in the yellow area of panel
2. Err(or E00) still shows or there is no function,
change the computer screen/display monitor.
E2
Control Board Error
Control board is
broken or
pseudo
soldering on control
board
Replace control board
E4
Control Board Error
Control board is
broken
Replace control board
E5
Overcurrent Protection
Control board short
circuit or motor
blocked
1. Open the motor cover and check whether the
motor is blocked. Remove the block if yes.
2. Replace the control board if it’s not blocked,
or the error still shows.
E6
Motor Error
Motor broken or motor
line fall off
1. Open the motor cover and check whether the
motor is broken or whether the motor wire is
connected to control board properly. Reconnect
the wire is recommended.
2. Replace the control board if the error still
shows.
E7
Communication
Failures
Wires from the control
board to panel board
are broken or not
properly connected
1. Make sure the wires from the control board
and panel board are connected securely and not
damaged.
2. Replace the control board if the error still
shows.
E8
Overload Protection
Excess of electricity or
user exceeded max
load weight
1. Make sure the user does not exceed max
weight capacity.
2. Reconnect power and re-start the machine.
3. Replace the control board if the error code still
shows.
Summary of Contents for SP36602
Page 1: ...USER S MANUAL MOTORIZED TREADMILL SP36602...
Page 3: ......
