P. 4
INSTALLATION
Before finally installing the unit, carry out a sound check. If high distortion or intermittent sound
is experienced, it is possible that the wiring to the car's electric is poor, or that the battery needs
recharging.
Use only the parts included with the unit to ensure a safe and secure installation.
Consult with your nearest dealer if installation requires the drilling of holes or other
modifications to the vehicle.
Choose a mounting location carefully so that the unit will not interfere with the normal driving
functions of the vehicle.
If installation angle exceeds 30° from horizontal, the unit might not give its optimum
performance.
Avoid installing the unit where it would be subject to high temperature, such as from direct
sunlight, or from hot air, from heater, or where it would be subject to dust dirt or excessive
vibration.
Be sure to remove the front panel before installing the unit.
DIN FRONT/REAR-MOUNT
This unit can be installed either from “Front” (conventional DIN Front-mount) or “Rear”(DIN
Rear-mount installation, utilizing threaded screw holes at the sides of the unit chassis). For details,
refer to the following illustrated installation methods A and B.
- DIN FRONT-MOUNT (Method A)
1. Dashboard
2.
Mounting sleeve
After inserting the half sleeve into the
dashboard, select the appropriate tab
according to the thickness of the
dashboard material and bend them
inwards to secure the sleeve in place.
3. Screw
30°
1
7
4
2
3
5
6
1. Dashboard
2. Nut (5mm)
3. Spring washer
4. Screw (4x12mm)
5. Screw
6. Support Strap
Be sure to use the support strap to
secure the back of the unit in place. The
strap can be bent by hand to the desired
angle.
7. Plain washer
182
53
1
2
3
