EN
- 14
• Make sure sand can never get into the Valve or Board. This could cause damage.
• In order to ensure the longevity and the good functioning of your Pump, do not hesitate to check from time to
time the lubrication of the piston inside your Pump by adding silicone grease if necessary.
• Never get on the Board when it is not on the water with the Fin installed : the fins and their Boxes are fragile
to misuse The warranty will not apply under any circumstances.
• Despite all your precautions, and the solidity of the PVC, it is possible that you manage to pierce your Board
on a very sharp rock for example. The PVC Patch that comes included in the product is there for any possible
repairs that you need to make. The Marine grade PVC Glue need for the job can be found at any hardware
store or specialty boat shop.
CARE AND MAINTENANCE
DEFLATION AND FOLDING
INSTALLATION OF THE FIN
1 - To deflate the Board, open
the Valve cover and press
the button to turn it down to
«deflate.» Do not be surprised
by the air that escapes from
the Valve.
2 - Remove the Fins. Fold your
Board in front of the lateral
Fins and then fold it between
the side Fins and the center
Fin. Do not force too much
too close to the boxes to avoid
crumpling the PVC around
them.
3 - Then roll up the Board, strap
it up and put it in its transport
bag.
1 - Insert the Fins into their boxes and push them in
completely.
2 - Once in place, insert the 4 screws with the
hexagonal wrench, do not over tighten. To remove
them, perform the reverse operation.
