EN
- 13
GONG-GALAXY.COM
INFLATION
Inflate your Board with the
GONG
Pump supplied with your Board. This pump has the required inflation
capabilities, tips and seals compatible with the Valve of your Board.
1 - Choose a soft, clean surface to unroll your
material.
2 - Open the inflation Valve cap on the front of the
board.
3 -
Make sure the Valve knob is in the up
position for the inflation phase
. Just press
the button and turn it to the right or left. If you
do not follow this recommendation, the board will
deflate when removing the hose from the valve.
Before proceeding with your first inflation, tighten
the valve with the black key that comes in the
repair kit to insure perfect functioning (instructions
in GOOD HABITS!!).
4 - Insert the Pump hose by screwing it in a quarter turn.
5 - Inflate to the required pressure which should be
between
15 and 20 PSI
. It is normal to hear a
small whistling of air at the Pump hose during
inflation. Indeed, the tightness of the pipe is never
perfect, but the losses are insignificant. Likewise,
the Pressure Gauge needle will only begin
to move when the internal pressure of the
board exceeds 5 PSI
: it is therefore normal that
it does not work from the first strokes Pump.
6 - Once the Board is inflated, disconnect the tip of
the pump, turning it a quarter turn and close the
Valve cap to seal it.
