Golz FS 240 SE, Operating Instructions Manual

Page: 5 / 47

FS 240 SE
Operating instructions
- 5-
02822410998
5006580-00
2.1 Basic operation and designated use of the machine
The machine has been built in accordance with state-of-the-art standards and the recognized safety
rules. Nevertheless, its use may constitute a risk to life and limb of the user or of third parties, or cause
damage to the machine and to other material property.
The machine must only be used in technically perfect condition in accordance with its designated use
and the instructions set out in the operating manual, and only by safety-conscious persons who are
fully aware of the risks involved in operating the machine. Any functional disorders, especially those
affecting the safety of the machine, should therefore be rectified immediately.
The machine is designed exclusively for sawing of abrasive building material. Using the machine for
purposes other than those mentioned above (such as for) is considered contrary to its designated use.
The manufacturer cannot be held liable for any damage resulting from such use. The risk of such
misuse lies entirely with the user.
Operating the machine within the limits of its designated use also involves observing the instructions
set out in the operating manual and complying with the inspection and maintenance directives.
2.2 Organizational measures
This operating manual must always be at hand at the place of use of the product and must be acces-
sible to the person operating the machine!
In addition to this operating manual, all other generally applicable legal and other mandatory
regulations relevant to accident prevention and environmental protection must be observed! Such
obligations may also comprise the handling of hazardous materials, provisioning and/ or wearing of
personal protective equipment, or road traffic regulations. This operating manual must be supplemen-
ted by instructions covering the duties involved in supervising and notifying special organizational
features, such as job organization, work flows or the person entrusted with the work.
Person entrusted with work on the product must have read the operating manual prior to taking up
work. This applies especially to persons working only occasionally on the product, e.g. during set-up
or maintenance activities. Check - at least from time to time - whether the personnel are carrying out
the work in compliance with the operating manual and paying attention to risks and safety-relevant
factors.
For reasons of safety, long hair must be tied back or otherwise secured, garments must be close-
fitting and no jewellery - including rings - may be worn. Severe injury may result from being caught by
moving parts of the machine. Personal protective equipment must be used wherever required by the
circumstances or by law (e.g. safety glasses, ear protectors, safety boots, suitable safety clothing).
Observe the regulations for prevention of accidents! Observe all safety precautions and warnings
attached to the product and always keep them in good and perfectly legible condition.
The personal protection equipment should consist of the following parts:
1 Helmet with protection of the ears
2/3 Visor or safety glasses / Dust mask
4 Protective gloves
5 Safety clothes
6 Safety boots