Golz FS 240 SE, Operating Instructions Manual

Page: 18 / 47

FS 240 SE
Operating instructions
- 18-
02822410998
5006580-00
In order to ensure trouble-free motor start, raise the machine, before you start it, by means of the hand
crank (Pos. 4) to such extent that the cutting disc has no soil contact.
Then turn the main emergency stop switch (Pos. 1) from "Off" to "On". To start the motor, turn the star-
delta connection switch (Pos.. 2) from "0" to "Star" and wait until the motor has reached its full speed.
Make sure that the rotational direction of the cutting disc is correct! As the circumstances require, the
rotational direction of the drive motor is to be reversed. Turn the star-delta connection switch (Pos. 2)
again to "0", press the emergency stop switch (Pos. 3) and pull off the power plug.
With a suitable screwdriver, the phase inverter in the appliance inlet can be turned. Connect the power
supply unit to the machine again, as described above, and start the machine again.
As soon as the motor has reached its full speed and full power, the star-delta connection switch (Pos.
2) can be turned from "Star" to "Triangle".
Before you lower the machine by means of the hand crank (Pos. 4), the mini ball valve (Pos. 5) is to
be opened. Lower the machine to such extent that you reach the desired cutting depth (Cutting Depth
Label). Pull then the indexing plunger (Pos. 6) on the control panel, so that it snaps into the catch disk
in order to fix the desired cutting depth.
Work with a steady feed pressure. Too high feed pressure leads to an overload of the motor and there
is the risk that the machine loses contact with the ground. Too low feed pressure can polish the
segments and make them blunt.
After the cutting operation raise the machine again by means of the hand crank (Pos. 4). Stop the
water feed, turn the star-delta connection switch (Pos. 2) again to "0".
Before transporting the machine, before changing the cutting disc or doing maintenance work, the
emergency stop switch (Pos. 3) is also to be pressed and the main emergency stop switch (Pos. 1) is
to be turned to "Off".
6
5
3 2
1
4