DOOR PANEL INSTALLATION
.
P
lace the embedding box
Pass the wiring through the hole made in the bottom
part of the embedding box Level and flush the
embedding box Once the embedding box is
placed, remove the protective labels from the
attaching door panel holes
.
.
.
ssembly the door panel modules
A
.
Insert the header DOWN marked in the lower module and fix it by screwing the
module shafts
Place the module spacer between lower and next modules, assuring that the spacer
adjustment notches are inside the panel Fix the module by screwing the shafts
epeat this procedure in case of door panels with one more
module (the maximum number of modules placed vertically is three
Insert the header UP marked in the last module and fix it by screwing the supplied
screws
.
.
.
R
).
.
77
DOOR PANEL INSTALLATION
ssembly the sound module
A
.
I
.
.
nsert the sound module in the grille module
For a proper assembly, align the light
push button and the microphone rubber
of the sound module with its corresponding
holes in the grille module
78
.
A
ssembling the EL500/V2PLUS microprocessor circuit
and the EL516 push buttons encoders
The EL500/V2PLUS circuit is to be assembled on the
top of the embedding box Insert the circuit in the
top flanges of the embedding box (1) Push-in the
circuit in the bottom flanges (2) by pressing the
pcb board
.
.
.
To assemble the EL516 encoder, screw the top tab of
the case to the corresponding plastic lug of the
embedding box
Place the circuit on the inferior flanges and screw
it into the embedding box
In case of more than one encoder, place them
underneath or in the next embedding box
The use of EL516 encoders is only necessary for
panels with more than 8 push buttons
Each encoder allows the connection of 15
push buttons
.
.
.
.
.
1
2
1
2
