89
Avoid placing the monitor near sources of heat, in
dusty locations or smoky environments
To install the monitor directly over the wall, drill two
holes of Ø6mm. and use the supplied screws
The upper part of the monitor connection block must
be placed at 1,60m. height roughly The minimum
distance between the monitor connection block and
the closest object must be
.
.
.
5cm.
Place the monitor at right angles to the
connection block and align the attaching
holes of the monitor with the attachment
hooks of the connection block, as it is
shown on the drawing
.
Lock out the monitor. Press the right side till the
attachment clip locks the monitor firmly
To disassemble the monitor from the connector,
use a plain screwdriver to release the
attachment clip Remove the monitor from
the connection block, taking special care
that it does not fall
.
.
.
.
F
ix the monitor connection block to the wall
ix the monitor
F
.
MONITOR INSTALLATION
90
Each apartment must have one master unit only; if there is a parallel unit, be it a
monitor or telephone, it must be configured as slave.
Make a call to check that the monitor has been successfully programmed
Repeat these steps to program the rest of monitors
Once the programming has finished, set the programming switch to
If you don't, the door panel will reproduce a sound to advise that the
system is still into programming mode
.
.
OFF.
.
.
P
rogramming the monitors
Locate the configuration dip switch situated under the protection
cover of the EL500/V2PLUS microprocessor circuit and set
umber 2 to ON as described on page
The door panel will reproduce a sound to advise that the system
has entered into programming mode
n
83.
.
6
With the door release push button pressed,
pick up the monitor's handset
.
To show that the system is ready for programming,
the door panel and the monitor's handset will
reproduce tones and an image will appear on the
monitor. Audio and video communication can
also be established
he door release push button can be released
.
T
.
P
.
.
ress the door panel push button that
will call to this monitor
At this moment both door panel and
handset will reproduce tones
To program the monitor as master, replace the handset
To program it as Slave press the lock release push
button once. After the door panel and handset reproduce a
short tone, replace the handset If a long tone is reproduced
then an error has occurred; reconfigure the monitor
.
1
.
.
Master 1 Slave
MONITORS PROGRAMMING
2 Slave
.
.
To program it as 2 Slave press the lock release push button
twice. After the door panel and handset reproduce two short
tones, replace the handset If a long tone is reproduced then
an error has occurred; reconfigure the monitor
double
click
st
st
nd
nd
